Battery installation and charging
Pair your first
Pair your first
Install the battery as shown below. For optimal
performance, charge the handset battery for at least
16 hours before use.
Bluetooth cell phone
To pair and connect your first Bluetooth cell phone:
Bluetooth headset
To pair and connect your first Bluetooth headset:
2. Insert the plug as
1. Press the tab and
Quick start guide
1. Press the MENU softkey on
indicated. Make sure
slide the battery
1. Press CELL on the
for model LS5146
it is plugged securely
and matches the
color-coded label
inside the battery
compartment.
the telephone base.
compartment cover
downwards.
telephone base.
Main Menu
2. Press the UP and DOWN
Install the telephone base
Voice Mail
Intercom
Bluetooth
NavKeys to highlight
Bluetooth, then press the
SELECT softkey.
Install the telephone base as shown below.
SELECT
Cellular operation
requires Bluetooth
2. Press the YES softkey.
connection.
DSL filter (not included) required
if you have DSL high-speed
Internet service
Set up Cellular?
Bluetooth
3. Press the UP and DOWN
YES
NO
Set up Cellular
Set up Headset
Active Devices
NavKeys to highlight
Set up Headset, then press
the SELECT softkey.
SELECT
3. Setyourcellphonetosearch
for or add new devices, then
press the NEXT softkey.
Set up Cellular
Set your Cellular to
search for devices,
then press NEXT
Electrical outlet
not controlled by
a wall switch
Telephone wall jack
4. Set your headset to
Set up Headset
3. Place the battery
with the label
4. Align the cover flat
NEXT
discoverable mode, then
press the NEXT softkey.
Set your Headset in
Discoverable mode,
against the battery
then press NEXT
THIS SIDE UP facing compartment, then
NEXT
up and the wires
inside the battery
compartment.
slide it upwards until it
clicks into place.
4. Once your cell phone finds
your VTech LS5146, select
it and then enter the PIN
0000 on your cell phone.
Set up Cellular
Power adapter
VTech LS5146
in Discoverable Mode
PIN=0000
5. Once the telephone base
Headsets Found
Mary’s Headset
finds your headset, select
it and then press the PAIR
softkey.
Telephone
line cord
STOP
HELP
FIND
INFO
PAIr
5. When pairing is completed,
press the YES softkey on
the telephone base.
Set up Cellular
Pairing complete
Connect to
Cellular ?
6. Enter your headset’s PIN
on the telephone base, then
press the DONE softkey.
The default PIN for most
headsets is 0000.
Set up Headset
Enter PIN:
0000
YES
NO
DONE
HELP
ErASE
Telephone base
5. Charge the
handset by
Cellular setup
completed
7. When the pairing is
completed, press the YES
softkey on the telephone
base.
Set up Headset
placing it in the
telephone base.
The handset
charge light on
the handset
Pairing complete
Connect to
Headset ?
NOTES:
YES
NO
1. Use only the power adapter and battery
supplied with your VTech telephone.
will be on when
charging.
2. For complete feature instructions, please refer
to your user’s manual.
Headset setup
completed
Charge light
|